Key Features of Baltmore Cooling tower fills&Hanging Fills
1. Greater cooling capacity in a given space
2.Low-clog designs available
3.Available in bottom supported or hanging designs
4. Integral louvers and eliminators available in crossflow
5.High-temperature designs availableigle-piece, full-height counterflow designs available
| Application |
Crossflow, Counterflow Cooling Tower |
| Shaping Mode |
Plastic Extrusion Mould |
Baltmore Cooling tower fills&Hanging Fillstechnical data MX Fill is available in MX75 configuration and higher-performing MX625 configuration. MX is a hanging film type cooling tower fill which spreads the water into a thin film, flowing over large vertical surfaces, promoting maximum exposure to air flow. This type of fill provides much more water surface exposure per cubic foot than splash type fill.
MX fill incorporates highly efficient cellular drift eliminators, integrally molded within the fill sheets. Compared with previous designs, these eliminators reduce drift emissions from the tower by a factor of ten or more! Less drift means tower owners save water bills and water treatment chemical expenses.
This fill virtually eliminates the nuisance caused by drift spotting on adjacent buildings and property. For additional savings, the drift eliminators discharge air directly toward the fan. Discharge air, traveling in the right direction when it leaves the eliminators, translates to lower fan horsepower.
Louvers are also integrally molded within the fill sheets preventing water from escaping and assuring precise air distribution throughout wide variations in airflow. Unlike towers equipped with separate external louvers, this fill operates virtually ice-free even in extremely cold weather.
MX fill is thermoformed from PVC with a flame spread rating less than 25 per ASTM E-84 and is considered selfextinguishing. Therefore, the risk of fire damage is minimal.
| Name |
Baltmore Cooling tower fills&Hanging Fills |
| Type |
Cross Flow Cooling Tower PVC Filler |
| Material |
PVC PP |
| Size |
1330mm*any*0.25mm-0.38mm(W*L*T) |
| Profile Height |
19mm |
| Inclination |
5° |
| Temperature suitable |
65ºC~ -35 ºC |
){kind=link}
){kind=link}